John-wood Power Direct Vent (Non-ENERGY STAR qualified model User Manual download pdf (Page 15)

– 15 –

Before plugging in the water heater, always make sure:

• The voltage and frequency correspond to that specified

on the water heater wiring diagram.

• The electrical outlet has the proper overload fuse or

breaker protection.

• Fill the tank with water and check all connections for

leaks. Open the nearest hot water faucet and let it run

for 3 minutes to purge the water lines of air and sedi-

ment and to ensure complete filling of the tank. The

electrical power may then be turned on. Verify proper

operation after servicing.

Note: Always reference the wiring diagram for the correct

electrical connections.

Resettable Lockout

The gas control/thermostat can be reset by unplugging the

power cord to remove power and then reinserting the plug

to restore the power. Robertshaw controls will automatically

attempt to reset after a 20 minute wait period. White-

Rodgers Intelli-Vent

controls will automatically reset after

a 60 minute wait period. Also see "Troubleshooting Guide".

Figure 14 Wiring Diagram - White-Rodgers Control

Figure 13 Robertshaw Wiring Diagram - (Typical)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

No comments

John-wood Power Direct Vent (Non-ENERGY STAR qualified model User Manual Page 15